This is an old revision of the document!

Day 1 ( Aug 8 )

I did some cleanups in the code today. I also implemented tg3_close() and tg3_remove_one(). Those were the last two missing functions and implementing them resulted in a successful first boot of the driver :).

Day 2 ( Aug 9 )

More cleanups. Removed most of the out-commented code that was left in the driver and some other simplifications. While going through the code I also compiled a list of suspicious looking things that I want to revisit the coming days.

Day 3 ( Aug 10 )

Not much coding today, but a lot of testing. Tested the driver with all 4 test cards I have available, testing:

  • Booting linux + initrd over HTTP and TFTP
  • Booting linux over iSCSI
  • Booting MSDOS over iSCSI, running scandisk on a 512MB iSCSI disk.

Interrupt support is not fully implemented yet, so UNDI chainloading tests were saved for later. Will see if I can get ahold of a Symantec Ghost DOS disk to stresstest the UNDI/interrupt support.

I was doing all that testing in Vienna and unfortunately forgot one test card there, so I only have 3 cards to test until the next time I get to Vienna(Probably next week).

Day 4 ( Aug 11 )

I moved kicking off autoneg to tg3_init_one() from tg3_open(). This results in the BANNER_TIMEOUT being used for auto negotiation, which should save a few seconds boot time, as autoneg can take up to 6 seconds to complete. struct tg3_napi was also removed and its fields merged into struct tg3.

QR Code
QR Code soc:2011:meteger:journal:week12 (generated for current page)