This is an old revision of the document!
<code c> skge_probe alloc_etherdev netdev_init pci_set_drvdata adjust_pci_device skge_get_register_address skge_hardware_reset skge_load_chip_identifiers skge_initialize skge_genesis_init skge_generic_init skge_stop_and_configure_clocks skge_devinit skge_supported_modes netdev_link_down netdev_link_up skge_open setup_rx_resources skge_ring_alloc refill_rx_ring populate_rx_descriptor setup_tx_resources skge_ring_alloc start_clocks software_reset_device skge_irq netdev_priv skge_transmit skge_avail skge_write8 skge_poll skge_extirq skge_process_tx skge_tx_done skge_process_rx skge_rx_desc skge_rx_get netdev_rx skge_refill_rx_ring populate_rx_descriptor skge_close skge_hardware_reset skge_configure_irq skge_free_tx_resources skge_free_rx_resources skge_remove pci_get_Drvdata unregister_netdev netdev_nullify netdev_put </code>
