[gPXE] Windows 7 transfer to a iSCSI target

[Ozan Yerli]

It hangs forever. When using the normal boot, the logo stays forever.
When using the safe mode, the list of drivers stays forever.

You can consider me as following the guide:
http://etherboot.org/wiki/sanboot/transfer since I want to migrate an
existing system to a network boot solution. The only difference is I
am not creating an image from the hard drive. I am directly connecting
the hard drive to the iscsi-target and I believe this should not make
a difference.

2010/6/5 Miller, Shao <Shao.Miller at yrdsb.edu.on.ca>:
> Ozan,
>
> Would it be fair to start with the HowTo guide, then move away from it
> once you've been through a good boot?
>
> Networking is critical for a SAN-boot.  I've not touched Windows 7, but
> in previous Windows OSs you had to make sure your NIC drivers were set
> to be loaded (and started) and boot-time.  Firewalls could also hinder
> you.
>
> Is it a crash or does it hang forever?  If it hangs forever, do you
> still see the list of drivers on the screen or something else?
>
> - Shao Miller
>