Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
winpe [2010/01/19 17:39] billmc added note regarding x64 support |
winpe [2010/06/05 07:34] (current) sha0 Add info about next-server DHCP option |
||
|---|---|---|---|
| Line 60: | Line 60: | ||
| ===== Configuring DHCP and TFTP ===== | ===== Configuring DHCP and TFTP ===== | ||
| - | Configure your DHCP server to hand out //"\Boot\pxeboot.n12"// as the boot filename. For ISC DHCPD, you can do this by adding | + | Configure your DHCP server to hand out //"\Boot\pxeboot.n12"// as the boot filename. |
| + | **For ISC DHCPD**, you can do this by adding the following to ///etc/dhcpd.conf//. | ||
| + | |||
| + | next-server XXX.XXX.XXX.XXX; | ||
| filename "\\Boot\\pxeboot.n12"; | filename "\\Boot\\pxeboot.n12"; | ||
| - | to ///etc/dhcpd.conf//. | + | where the **next-server** details either the IP address or DNS hostname of your TFTP server. |
| {{ :warning.png}} | {{ :warning.png}} | ||
| - | Note that you **must** use a backslash (\) as the path separator, rather than the more usual forward slash (/). If you use a forward slash, //pxeboot.n12// will be unable to locate //bootmgr.exe// and the boot will fail. Your TFTP server must be configured to support the use of backslashes as path separators; see [[:tftp_backslash|Supporting broken TFTP clients]] for instructions on configuring your TFTP server to do this. | + | <sub>Note that you **must** use a backslash (\) as the path separator, rather than the more usual forward slash (/). If you use a forward slash, //pxeboot.n12// will be unable to locate //bootmgr.exe// and the boot will fail. Your TFTP server must be configured to support the use of backslashes as path separators; see [[:tftp_backslash|Supporting broken TFTP clients]] for instructions on configuring your TFTP server to do this. |
| + | |||
| + | Note also that each backslash is doubled within ///etc/dhcpd.conf//; this is because ISC DHCPD treats a backslash as an escape character.</sub> | ||
| + | |||
| + | **For Microsoft DHCP Server**, set the following options | ||
| + | |||
| + | Option Number Option Name Value | ||
| + | 066 Boot Server XXX.XXX.XXX.XXX | ||
| + | 067 Bootfile Name boot\pxeboot.n12 | ||
| - | Note also that each backslash is doubled within ///etc/dhcpd.conf//; this is because ISC DHCPD treats a backslash as an escape character. | + | where option 66 refers to your TFTP server's IP address or DNS hostname. |
| ===== Booting WinPE ===== | ===== Booting WinPE ===== | ||
