Differences

This shows you the differences between two versions of the page.

--- soc:2010:andreif:journal:week6 [2010/06/30 08:21]
andreif
+++ soc:2010:andreif:journal:week6 [2010/07/05 06:39] (current)
andreif
@@ Line 62: / Line 62: @@
 The .close routine disables interrupts, stops rx and tx, and clears up the rings basically. Tomorrow I'll clear the rings and implement the ''nv_drain_rxtx'' routine. I'll also do the switch setup that Stefan suggested and see if .open and .close work :)
+==== Day 4 [ Thu 1 Jul 2010 ] ====
+me.away()
+==== Day 5 [ Fri 2 Jul 2010 ] ====
+Today I started to set up the switch, which in fact is a [[http://www.productwiki.com/siemens-gigaset-se361-wlan/|router]]. Every issue mentioned in that page, I encountered it. I had to make some settings multiple times before the router saved them, plus it disconnects every now and then. I disabled its internal DHCP server, its DNS, and enabled NAT, and now the setup looks like this:
+<code>
++-------------+
+|192.168.2.101|
++             +
+| DHCP server |
++             +    +--------------+
+|   dev PC    |    | forcedeth PC |
++-------------+    +--------------+
+       |             |
+     +------------------+
+     |    192.168.2.1   |
+     +                  +
+     | best router ever |
+     +------------------+
+            |
+     +-------------+
+     |teh internets|
+     +-------------+
+</code>
+After that, I installed dhcp-server3 on my dev box and set it up. This took some time and I ran into some issues because I didn't have my IP statically configured. In the end, I booted a DSL from the dev pc using the old forcedeth driver. Tomorrow, I'll configure it so it gets an image containing my forcedeth driver and finally test it.
+The amount of issues with that router are staggering, and I hope now that it is stable, I can finally get some work done. I see some mentioning of low speeds when using it so I'll keep this in mind when I test the driver's speeds.
+==== Day 6 [ Sat 3 Jul 2010 ] ====
+me.rest()
+==== Day 7 [ Sun 4 Jul 2010 ] ====
+Finally got around to testing .open and .close and they seem to work fine. I'll only be sure of this when I implement .transmit and .poll and see if the settings made in .open are correct.
+Got some nice feedback regarding the driver after the weekly meeting. The plan is to finish the driver until the end of the next week. So far so good.

Trace:

Differences

Navigation

Search

Toolbox

QR Code