Differences

This shows you the differences between two versions of the page.

--- soc:2009:dverkamp:journal:week4 [2009/06/16 16:13]
drv
+++ soc:2009:dverkamp:journal:week4 [2009/06/18 16:19] (current)
drv
@@ Line 18: / Line 18: @@
 Using fdisk, I made the partition on the disk image used by the iSCSI target active/bootable.  This allowed the boot to proceed, but then I get the error message "BOOTMGR is missing/Press Ctrl+Alt+Del to restart".
+==== Wednesday, June 17 ====
+Restarted Win7 iSCSI install test to be sure the environment was consistent.  Erased MBR on physical disk on test machine (''dd if=/dev/zero of=/dev/hda bs=512 count=1''), deleted iSCSI disk and created a new one (20 GB this time to be sure space requirements would be met), and started from scratch.
+The same results as before were observed: Windows would not install on the iSCSI disk without the physical disk connected, and it installed the bootloader on the physical disk, not the iSCSI target.  The physical disk contains bootmgr and the related infrastructure.  The iSCSI partition was also not marked active.
+I also attempted to perform the procedure in QEMU, but the Windows 7 installer got stuck for over an hour on the stage before disk selection, so it could not be tested.
+==== Thursday, June 18 ====
+Installed Win7 on a physical hard disk in the test machine and transferred it to the iSCSI target, ran sanbootconf, then attempted to boot it from there.  This booted farther than the iSCSI-installed version (it actually had a proper bootloader installed), but it did not boot completely, possibly due to a missing NIC driver.

Trace:

Differences

Navigation

Search

Toolbox

QR Code