Differences

This shows you the differences between two versions of the page.

--- sanboot:winnt_iscsi [2008/12/16 11:39]
mcb30
+++ sanboot:winnt_iscsi [2009/02/19 12:07]
mcb30
@@ Line 17: / Line 17: @@
 {{ :screenshots:winnt_iscsi_no_multipath.png?503x386 |Deselecting MPIO support}}
-Make sure to enable the "Configure iSCSI Network Boot Support" option, and to select the network card that will be used for iSCSI boot.
+If you are presented with the option to "Configure iSCSI Network Boot Support", then you must enable this option and select the network card that will be used for iSCSI boot.
 {{ :screenshots:winnt_iscsi_boot_nic.png?503x386 |Selecting boot NIC}}
@@ Line 23: / Line 23: @@
 After installation is complete, reboot the system and check that it boots up correctly.
-You are now ready to:
+If you are using Windows 2003 or later, and were given the option to "Configure iSCSI Network Boot Support" during installation, then you are now ready to:
-  * [[sanboot:transfer|Transfer the Microsoft Windows disk image to your iSCSI target]]
+  * [[:sanboot:transfer|Transfer the Microsoft Windows disk image to your iSCSI target]]
+If you are using Windows XP, or were not given the option to "Configure iSCSI Network Boot Support" during installation, then you must now
+  * [[:sanboot:winnt_iscsi_sanbootconf|Install the SAN Boot Configurator]]

Trace: