This is an old revision of the document!
Assuming your kernel source tree has been decompressed properly, and you created the correct symbolic link. Change to the new source directory.\\ cd /usr/src/linux\\ Clean the source tree. ( make clean )\\ Dig into the menuconfig for the kernel. ( make menuconfig ) The following kernel options must be set in order to boot your kernel over etherboot.\\ Under "Networking --> Networking options" : [*] TCP/IP networking [*] IP: kernel level autoconfiguration [*] IP: DHCP support [*] IP: BOOTP support Under "File systems" : [*] Second extended fs support [ ] Ext2 extended attributes [ ] Ext2 execute in place support [*] Ext3 journalling file system support [*] Ext3 extended attributes [ ] Ext3 POSIX Access Control Lists [ ] Ext3 Security Labels Under "File systems --> Network File Systems" : [*] NFS file system support [*] Provide NFSv3 client support [*] Root file system on NFS Compiling the ext2 and ext3 file systems into the kernel, rather than modules makes sense for now.\\ The above options are not the only thing you will need to get your nodes up and booting.\\ You will need motherboard specific modules, for the computer you will be booting. An easy way to get a list is to boot a gentoo install cd, or another system that you trust. Once in the shell, get a list of loaded modules. ( lsmod ) Write down the lsit, research the hardware. Use those modules in the future. For this document, I need the MPTSAS sas drivers, TG3 network card, make make modules_install
