Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Last revision Both sides next revision | ||
|
elf-ebi-initramfs-lnxi-howto:the_kernel:the_kernel_2 [2009/04/29 12:07] jmcdowell A |
elf-ebi-initramfs-lnxi-howto:the_kernel:the_kernel_2 [2009/04/29 14:02] jmcdowell |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | Assuming your kernel source tree has been decompressed properly, and you created the correct symbolic link. | + | Assuming your kernel source tree has been decompressed properly, and you created the correct symbolic link. Change to the new source directory.\\ |
| + | cd /usr/src/linux\\ | ||
| + | Clean the source tree. ( make clean )\\ | ||
| + | Dig into the menuconfig for the kernel. ( make menuconfig ) The following kernel options must be set in order to boot your kernel over etherboot.\\ | ||
| + | |||
| + | Under "Networking --> Networking options" : | ||
| + | [*] TCP/IP networking | ||
| + | [*] IP: kernel level autoconfiguration | ||
| + | [*] IP: DHCP support | ||
| + | [*] IP: BOOTP support | ||
| + | |||
| + | Under "File systems" : | ||
| + | [*] Second extended fs support | ||
| + | [ ] Ext2 extended attributes | ||
| + | [ ] Ext2 execute in place support | ||
| + | |||
| + | [*] Ext3 journalling file system support | ||
| + | [*] Ext3 extended attributes | ||
| + | [ ] Ext3 POSIX Access Control Lists | ||
| + | [ ] Ext3 Security Labels | ||
| + | |||
| + | |||
| + | Under "File systems --> Network File Systems" : | ||
| + | [*] NFS file system support | ||
| + | [*] Provide NFSv3 client support | ||
| + | [*] Root file system on NFS | ||
| + | |||
| + | Compiling the ext2 and ext3 file systems into the kernel, rather than modules makes sense for now. I am uncertain if one could ever compile ext2 as a module and still boot due to the initramfs.\\ | ||
| + | The above options are not the only thing you will need to get your nodes up and booting.\\ | ||
| + | You will need motherboard specific modules, for the computer you will be booting. An easy way to get a list is to boot a gentoo install cd, or another system that you trust. Once in the shell, get a list of loaded modules. ( lsmod ) Write down the list in use. Then deselect any modules you do not need, making sure you have selected the modules that you do need. | ||
| + | |||
| + | [[elf-ebi-initramfs-lnxi-howto/the_kernel/the_kernel_3 | Nett]] | ||
