• Documentation can be found here: http://wikis.sun.com/display/OpenSolarisInfo/Configuring+iSCSI+Boot+for+x86+Systems

• A Solaris Express Community Edition (SXCE) Build 104 or later DVD

• Create an empty disk and expose over iSCSI

• Make sure the DVD-ROM is activated as second boot device (in bios)

• During install choose the Solaris Interactive mode (default).

• Once the network configuration is done, exit the installer (go to a shell)

• Use the iscsiadm command to connect your iSCSI Target

 # iscsiadm add static-config iqn,target-ip:port 
 # iscsiadm modify discovery -s enable

 # iscsiadm add discovery address <target-ip>
 # iscsiadm modify discovery -t enable

# iscsiadm list target -S

• If the Device OS name is not specified, try:

# devfsadm -i iscsi

• run:

# install-solaris

• The installer should continue, and the iscsi disk should be available

• After specifying the target LUN, type install-solaris. When the install wizard appears, select Next to resume the installation.

• Opensolaris SXCE build 129 was successfully installed, on a system using a Realtek 8168 NIC

• I tried to create an image of this disk, to deploy new clients. For some reason if the target IQN is changing I can't boot anymore.