Shao, Andrey,<br /><br />Will that work?  I was about to suggest he remove the MBR from the drive.  I thought that the MBR code that loads Windows Boot Manager stops the boot process entirely when the boot manager isn&#39;t found.<br /><br />Well, Andrey, if what Shao says will work, then do that.  If not, connect to your iSCSI target using a working system and remove the MBR from it and you&#39;ll get your desired result.  The &quot;startup repair&quot; section of your Windows CD should fix the issue.<br /><br />-Andrew Bobulsky<br /><br /><br /><br />On Mar 23, 2010 10:40am, &quot;Miller, Shao&quot; &lt;Shao.Miller@yrdsb.edu.on.ca&gt; wrote:<br />&gt; Good day Andrey,<br />&gt; <br />&gt; <br />&gt; <br />&gt; In regards to your request to use gPXE to register a drive but not boot<br />&gt; <br />&gt; from it, the &quot;Install direct to SAN&quot; link from the &quot;HowTo Guides&quot; lands<br />&gt; <br />&gt; you here[1].  That might help for understanding the &quot;keep-san&quot; setting<br />&gt; <br />&gt; and how it can be used to maintain the iSCSI connection after control<br />&gt; <br />&gt; returns back to gPXE from an unbootable MBR.<br />&gt; <br />&gt; <br />&gt; <br />&gt; If you have a valid MBR on the SAN and no active partitions, return<br />&gt; <br />&gt; should control back to gPXE.<br />&gt; <br />&gt; <br />&gt; <br />&gt; - Shao Miller<br />&gt; <br />&gt; _______________________________________________<br />&gt; <br />&gt; gPXE mailing list<br />&gt; <br />&gt; gPXE@etherboot.org<br />&gt; <br />&gt; http://etherboot.org/mailman/listinfo/gpxe<br />&gt;