<!DOCTYPE HTML PUBLIC "-//W3C//DTD HTML 4.0 Transitional//EN">
<HTML><HEAD><TITLE></TITLE>
<STYLE></STYLE>
</HEAD>
<BODY text="#000000" bgColor="#ffffff">
<DIV><FONT face="Arial" size="2">I've been trough that message a couple of times
before I managed to install windows 7,</FONT></DIV>
<DIV><FONT face="Arial" size="2">eventually I managed to install using PXE
chainloading, and WinPE 3.0, and did that many time over since.</FONT></DIV>
<DIV><FONT face="Arial" size="2"></FONT> </DIV>
<DIV><FONT face="Arial" size="2">have you added 'set keep-san 1' to the command
sequence? (according to my experience, the disk still shows up without
it! but not installable)</FONT></DIV>
<DIV><FONT face="Arial" size="2"></FONT> </DIV>
<DIV><FONT face="Arial" size="2">you can also try what I did, and boot without any
local media: after iscsi fail, fallback to WinPE 3.0 via tftp. this might help,
because gPXE will stay loaded.</FONT></DIV>
<DIV><FONT face="Arial" size="2"></FONT> </DIV>
<DIV><FONT face="Arial" size="2">it also helps to install to empty disk, and
then create partition, make it active and assign it (just before
installation).</FONT></DIV>
<DIV><FONT face="Arial" size="2">if all else fail, try using another software
target. (Microsoft iSCSI software target require that you use 'set gateway' to
the server immediately after dhcp)</FONT><FONT face="Arial" size="2"></FONT></DIV>
<DIV><FONT face="Arial" size="2"></FONT> </DIV>
<DIV><FONT face="Arial" size="2">Tal</FONT></DIV></BODY></HTML>