[gPXE] Fails to get an address under gpxe, gets one under pxe

[Thomas Miletich]

Hello
There was a big modification to the eepro100 driver a few releases back,
this could be a bug introduced then. Please try a version with the old
driver(0.9.7 should work) and tell us your results.

13.04.2010 23:24 schrieb am <tra26 at cs.drexel.edu>:

Hello,

Using a eepro100 card (full description below), gpxe detects the card and
tries to dhcp from it but the connection times out. Normal pxe however
gets an address (and I cannot chain gpxe because of the setup). This
happens with git and 1.0.0 both built from source and from rom-o-matic.
Because the system refuses to read the .usb image (when dd'd to a device)
I am using syslinux as the boot loader.

Steps taken
Generate gpxe.lkrn via rom-o-matic/src.
mkdiskimage -4 /dev/sdb 0 64 32
syslinux /dev/sdb
mount /dev/sdb4 /mnt/disk
cp gpxe.lkrn /mnt/disk/gpxe.lkrn
modify syslinux.cfg
and boot.


Card information (pciconf -lv)
fxp0 at pci0:1:3:0:        class=0x020000 card=0x10408086 chip=0x12298086
rev=0x0c
hdr=0x00
   vendor     = 'Intel Corporation'
   device     = '82550/1/7/8/9 EtherExpress PRO/100(B) Ethernet Adapter'
   class      = network
   subclass   = ethernet


Thanks.

_______________________________________________
gPXE mailing list
gPXE at etherboot.org
http://etherboot.org/mailman/listinfo/gpxe
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://etherboot.org/pipermail/gpxe/attachments/20100414/be6d4b0b/attachment.html